Laser Power Supply Main Feature:
- PFC wide voltage AC90V-AC250V input
- High intelligence: Laser Power Supply can communicate with motion controller, the controller panel can display power supply working condition, the users can know and judge the fault easily.
- Open circuit protection function: if the output high voltage open circuit or not connected well, the power supply will automatically cut off the high voltage.
- High voltage discharge function: no residual voltage after turn off, very safe for user.
|AC frequency||47 — 440Hz|
|Max input power||500W||700W||900W|
|Max input current||6A||8A||10A|
|Max output voltage||40KV||45KV||55KV|
|Max output current||28mA||32mA||38mA|
|Efficiency||90% full load|
|Laser Power Supply MTBF||10000 hours|
|Response speed||1mS (the time from the signal is given to output current reaches 90% of set current)|
|Switch control mode||TTL|
|Power control mode||PWM (>20KHz) or 0-5V or 0-3.3V analogue|
|Communication mode||Special serial port|
|Withstand voltage||Input-output, input-shell AC1500V 10mA 60s|
|Working enviroment||Temperature (-10~40) ºC, relative humidity: 90%|
|Cooling||Forced air cooling|
|Dimension||235*144*104 mm||278*144*104 mm||330*144*104 mm|
|Weight||2.15 KG||2.45 KG||3.2 KG|
High-voltage Power Supply
A high-voltage power supply is one that outputs hundreds or thousands of volts. A special output connector is used that prevents arcing, insulation breakdown and accidental human contact.
Our power supplies have protection from short circuit or overload that can damage the laser tube or cause a fire. We use fuses for overload protection.
The suitability of a particular Power Supply for an laser cutting machine is determined by various attributes of the power supply, which are typically listed in the power supply’s specification. Commonly specified attributes for a Laser Power Supply include:
- Input voltage
- Output voltage
- Output current
Recommended source according to laser tube power:
The P2 source is recommended for tubes between 80w and 90w.
The P4 source is recommended for tubes between 100w and 130w.
The P6 source is recommended for tubes between 130w and 160w.